null

Modine PDP175AE0130 175,000 BTU Vertical Powered Vented Unit Heater - 115V - NG

Sku:
MODINE-PDP175AE0130
Please Call (877) 847-0050 for Availability
$2,309.00
Featuring 80% thermal efficiency, these unit heaters use a collector box and power exhauster for maximum seasonal efficiency. Unit can be used vertically or horizontally and the exhaust can be rotated a full 180°. These units are designed to use the smallest diameter vent pipe possible. Included is an intermittent pilot-ignition, 100% shut off, and automatic restart.
  • Single Stage Gas Valve
  • Continuous Restart: The system will attempt to light the pilot for 70 seconds. If the pilot is not sensed for any reason, the ignition control will wait for approximately six minutes with the combination gas control closed and no spark. After six minutes, the cycle will begin again. After three cycles, some ignition controllers lockout for approximately one hour before the cycle begins again. This will continue indefinitely until the pilot flame is sensed or power is interrupted to the system
  • Time Delay Relay: Allows the gas controls to operate for approximately 30 to 90 seconds before the blower starts. This allows the heat exchanger a warm up period so that the initial delivered air is not cool. The time delay relay also keeps the motor running for approximately 30 - 90 seconds after the call for heat has been satisfied to remove the residual heat from the heat exchanger.
  • Low Voltage Terminal Board
  • Control Step Down Transformer
  • High Limit Switch
  • Pressure Switch: A automatic reset vent pressure switch is supplied on all power vented unit heaters to prevent operation of the main burner in the event there is restricted venting of flue products. After the cause of the restriction has been corrected, the pressure switch will reset automatically

The Modine PDP175AE0130 is Natural Gas.

FREE SHIPPING ON ALL ORDERS!
Modine PDP175 175,000 BTU Vertical Powered Vented Unit Heater, 115V

Product Overview

Featuring 80% thermal efficiency, these unit heaters use a collector box and power exhauster for maximum seasonal efficiency. Unit can be used vertically or horizontally and the exhaust can be rotated a full 180°. These units are designed to use the smallest diameter vent pipe possible. Included is an intermittent pilot-ignition, 100% shut off, and automatic restart.
  • Single Stage Gas Valve
  • Continuous Restart: The system will attempt to light the pilot for 70 seconds. If the pilot is not sensed for any reason, the ignition control will wait for approximately six minutes with the combination gas control closed and no spark. After six minutes, the cycle will begin again. After three cycles, some ignition controllers lockout for approximately one hour before the cycle begins again. This will continue indefinitely until the pilot flame is sensed or power is interrupted to the system
  • Time Delay Relay: Allows the gas controls to operate for approximately 30 to 90 seconds before the blower starts. This allows the heat exchanger a warm up period so that the initial delivered air is not cool. The time delay relay also keeps the motor running for approximately 30 - 90 seconds after the call for heat has been satisfied to remove the residual heat from the heat exchanger.
  • Low Voltage Terminal Board
  • Control Step Down Transformer
  • High Limit Switch
  • Pressure Switch: A automatic reset vent pressure switch is supplied on all power vented unit heaters to prevent operation of the main burner in the event there is restricted venting of flue products. After the cause of the restriction has been corrected, the pressure switch will reset automatically

The Modine PDP175AE0130 is Natural Gas.

Tech Specs

General Features

Installation Type:
Ceiling Mount
Fuel Type:
Natural Gas (NG)
Certified Usage:
Commercial (Indoor Only)
Separated Combustion Chamber:
No

Performance

Heating BTUs (Input):
175000
Heating BTUs (Output):
145250

System Data

Noise Level (dBA):
NA
Thermal Efficiency:
82%
CFMs:
2550
Output Velocity (FPMs):
959
Discharge Air Temperature Rise (°F):
51
Discharge Air Opening Area (ft²):
NA

Connections

Gas Connection Size:
1/2"
Vent Connection Size (in.):
5"

Clearances

Top to Ceiling (in.):
4"
Bottom to Floor (ft.):
1'
To Side Wall (in.):
1"
Access Panel (in.):
18"
Flue / Vent Connector (in.):
6"

Weights and Dimensions

Width (in.):
23.5
Depth (in.):
22
Height (in.):
35.25
Net Weight (lbs.):
175

Electrical Requirements

Voltage:
110-120V
Amps:
4.55
Circuit Breaker Size (Amps):
15
California residents see Prop 65 WARNINGS

Warning WARNING!

Warning: Cancer and Reproductive Harm - www.p65warnings.ca.gov

Product Warranty

Heat Exchanger: 10 Years