Modine PDP300AE0185 300,000 BTU Vertical Powered Vented Unit Heater - 115V - LP

Sku:
MODINE-PDP300AE0185
Please Call (877) 847-0050 for Availability
$3,185.00
The PDP300AE0185 has 300000 BTU input with 246,000 BTUs output and can be vented vertically or horizontally. It features an 82% thermal efficiency and uses a collector box and power exhauster for maximum seasonal efficiency. These units are designed to use the smallest diameter vent pipe possible and have an intermittent pilot-ignition system.
  • Ignition controller: The system will attempt to light 3 times (every 6 minutes) before lockout and re-attempt ignition after about an hour. This will continue indefinitely until the pilot flame is sensed or power is interrupted to the system
  • Time Delay Relay: The time delay relay allows the gas controls to operate for approximately 30 to 90 seconds before the blower starts, so that the initial delivered air is not cool. The time delay relay also keeps the motor running for approximately 30 - 90 seconds after the call for heat has been satisfied to remove the residual heat from the heat exchanger
  • Control Step Down Transformer: The transformer is used to step down the supply power (115V, 208V, 230V, 460V, 575V) to 24V for the gas controls, fan delay relay, field supplied motor starter, etc
  • High Limit Switch: The automatic reset high limit switch is factory installed on the side of the unit heater. If the limit temperature is exceeded, the gas controls are de-energized until the switch is cooled
  • Pressure Switch: A automatic reset vent pressure switch is supplied on all power vented unit heaters to prevent operation of the main burner in the event there is restricted venting of flue products. This restriction may occur due to an improper vent diameter, long vent runs, un-approved vent terminal, high winds, high negative pressure within space, etc. After the cause of the restriction has been corrected, the pressure switch will reset automatically
  • Power Exhauster: All power vented unit heaters are supplied with a round vent pipe connection. The power exhauster may be rotated 180° to allow for various venting directions

The PDP300AE0130 is Liquid Propane.

FREE SHIPPING ON ALL ORDERS!
Modine PDP300 300,000 BTU Vertical Powered Vented Unit Heater 115V

Product Overview

The PDP300AE0185 has 300000 BTU input with 246,000 BTUs output and can be vented vertically or horizontally. It features an 82% thermal efficiency and uses a collector box and power exhauster for maximum seasonal efficiency. These units are designed to use the smallest diameter vent pipe possible and have an intermittent pilot-ignition system.
  • Ignition controller: The system will attempt to light 3 times (every 6 minutes) before lockout and re-attempt ignition after about an hour. This will continue indefinitely until the pilot flame is sensed or power is interrupted to the system
  • Time Delay Relay: The time delay relay allows the gas controls to operate for approximately 30 to 90 seconds before the blower starts, so that the initial delivered air is not cool. The time delay relay also keeps the motor running for approximately 30 - 90 seconds after the call for heat has been satisfied to remove the residual heat from the heat exchanger
  • Control Step Down Transformer: The transformer is used to step down the supply power (115V, 208V, 230V, 460V, 575V) to 24V for the gas controls, fan delay relay, field supplied motor starter, etc
  • High Limit Switch: The automatic reset high limit switch is factory installed on the side of the unit heater. If the limit temperature is exceeded, the gas controls are de-energized until the switch is cooled
  • Pressure Switch: A automatic reset vent pressure switch is supplied on all power vented unit heaters to prevent operation of the main burner in the event there is restricted venting of flue products. This restriction may occur due to an improper vent diameter, long vent runs, un-approved vent terminal, high winds, high negative pressure within space, etc. After the cause of the restriction has been corrected, the pressure switch will reset automatically
  • Power Exhauster: All power vented unit heaters are supplied with a round vent pipe connection. The power exhauster may be rotated 180° to allow for various venting directions

The PDP300AE0130 is Liquid Propane.

Tech Specs

General Features

Installation Type:
Ceiling Mount
Fuel Type:
Liquid Propane (LP)
Certified Usage:
Commercial (Indoor Only)
Separated Combustion Chamber:
No

Performance

Heating BTUs (Input):
300000
Heating BTUs (Output):
249000

System Data

Nosie Level (dBA):
NA
Thermal Efficiency:
82%
CFMs:
4460
Output Velocity (FPMs):
1123
Discharge Air Temperature Rise (°F):
50
Discharge Air Opening Area (ft²):
NA

Connections

Gas Connection Size:
1/2"
Vent Connection Size (in.):
6"

Clearances

Top to Ceiling (in.):
5"
Bottom to Floor (ft.):
1'
To Side Wall (in.):
1"
Access Panel (in.):
18"
Flue / Vent Connector (in.):
7"

Weights and Dimensions

Width (in.):
28.625
Depth (in.):
25
Height (in.):
40.25
Net Weight (lbs.):
269

Electrical Requirements

Voltage:
110-120V
Amps:
9.85
Circuit Breaker Size (Amps):
15
California residents see Prop 65 WARNINGS

Warning WARNING!

Warning: Cancer and Reproductive Harm - www.p65warnings.ca.gov

Product Warranty

Heat Exchanger: 10 Years